DIY Lube Tubes

What you’ll need:

1 Pringles can

2 large sponges OR bubble wrap

1 latex glove

1 rubber band

Lube

Step 1: Remove Pringles.

Step 2: Place your glove between your sponges with the wrist end sticking out. If you’re going to use bubble wrap, simply roll the glove up, bubbles facing inward, also with the glove’s cuff hanging out.

Step 3: Push your sponges into the Pringles can until flush with the lip.

Step 4: Wrap the hanging end of the glove around the lip of the can, and seal with your rubber band.

Step 5: Lube her up and let the games begin!

Note: If there is too much suction or pressure while using your cum can, make a small incision in the bottom of the can to push out the air with each pump.

What you’ll need:

1 hand towel

2 rubber bands

1 tube of toothpaste

1 latex glove

Lube

Step 1: Place your toothpaste tube into the rubber glove.

Step 2: Take that glove and lay it on one end of the towel, with about an inch of the open end of the glove hanging beyond the edge.

Step 3: Roll the towel up around the toothpaste and glove.

Step 4: Wrap one rubber band around each end of the towel to keep it from unrolling.

Step 5: Remove the toothpaste tube. You’ll notice there’s a schlong-sized space in your rolled towel now. Thank you, toothpaste.

Step 6: Take the overhanging part of the glove and stretch it around the lip of the towel. You can even tuck it beneath the rubber band to keep it in place.

Step 7: Dribble a bit of lube into the opening of the glove, and voila! Your very first DIY Fleshlight!

What you’ll need:

1 latex glove

3 pairs of socks (your length or longer)

2 rubber bands

Lube

Step 1: Take a pair of socks, stacked side-by-side and lay them down on top of each other.

Step 2: Fold in the toes of the sock pair about an inch or so, then rest your latex glove on top of them with a bit of the open end hanging past the edge of the folded toes.

Step 3: Take your second pair and lay them on top of the glove, also with the toes folded inward toward the glove. This will make one end of your sock-glove-sock sandwich thicker and sturdier than the rest.

Step 4: Stretch and wrap the overhanging cuff of your glove around the folded toe end of your socks. Use a rubber band to keep it in place. You’ll see now that the opening of your suck sucker pocket pussy is almost ready for action.

Step 5: Take your third pair of socks and wrap them around the middle of your DIY pocket pussy for an extra thick grip. Seal that sucker with a rubber band.

Step 6: Squirt some lube in the opening and get to it!

What you’ll need:

1 roll of toilet paper

1 latex glove

1 rubber band

Lube

Step 1: Remove the cardboard tube from your toilet paper roll and toss it.

Step 2: Stick your glove through the center of the hole with at least an inch of the cuff hanging out.

Step 3: Stretch the glove’s cuff all the way around the outside of the roll. If it doesn’t reach, you may need to unwind the toilet paper a bit to make the roll smaller. Then seal with a rubber band.

Step 4: Lube!